An Orbi router must get an IP address from the modem if you want the mesh network to perform at subpar. It is the connection between Orbi router and modem and that between the satellite and router due to which the Orbi satellite colors turn blue representing a good internet connection. But, this good connection will only remain an imagination if the router does not get the IP. This piece of writing is all about addressing such a weird problem. Read on.
Resolved: Orbi Router Not Getting IP Address
There can be a hoard of reasons due to which your router from Netgea Orbi might be denying the connection with the modem and getting no IP. But, the number 1 reason is the connection between them. Everyone knows that a router connects to the modem via an Ethernet cable. Thus, there are higher chances that the cable connection between your devices is not up to the mark. What we mean to say is that the LAN cable might be damaged. Thus, we recommend you replace it with a new one.
1. Restart the Router
Since we find you on this technique this means that the LAN cable was never the reason why your Orbi was not getting the IP address. Well, an improperly booted up router can also be the reason behind this problem. So, why don’t you boot up the router again? Yes, that will be a restart for your Orbi. Thus, restart the router using the following instructions: · Power down the Orbi and disconnect its power cord from its respective outlet.· The next thing in line is to wait for some seconds or minutes.· Done? Do the reverse of what you just did before waiting. 2. Check the LAN PortsChecking the Ethernet cable is not the only thing that you were supposed to do in order to ensure that the connection between your Netgear Orbi and the modem. You are also supposed to check the LAN ports that means the LAN 1 port of the modem and the Internet port of your router. These ports are supposed to be clean as well as well working. 3. Relocate the Router
There are chances that the problem has arisen because of the wrong location of your Orbi router. Wondering how a location can affect the IP getting ability of your Orbi? Well, that can happen if the router sits in an area that is filled with WiFi interference creating factors. To be very specific, there are chances that your router is placed very close to devices emitting electromagnetic frequencies, objects containing a large amount of water, or reflexive surfaces. Therefore, it is advised that you assign a new location to your WiFi router and observe if it gets the IP from the modem now. Note: If the above-given hacks don’t work for you, it is advised that you restart the modem too. The process is as same as rebooting the Orbi router. 4. Reset the Orbi
If you are still running out of luck, then you are left with no hack other than performing a factory default reset of your Orbi router. For this, it is advised that you locate the Reset button of the router and press it. For your information, the button can’t be pressed with fingers. You have to use a sharp object for that. Thus, get hold of the same and press the button. Keep it held for a few seconds and release. After that, access the Orbilogin address on your PC and set up the router again.
The Concluding Thought
That’s all about why the Netgear orbi router fails to get the IP address modem. Since we’ve also given the troubleshooting hacks along with the reasons causing the issue, we are assuming that using them, you will be able to resolve the issue.